How to maintain the lighting effect of LED Bollard Light under bad weather conditions?

1. Waterproof design
Shell sealing: Choose a shell material with a high waterproof grade, such as IP65 or higher waterproof design, to ensure that the shell joints are well sealed to prevent rainwater from penetrating.
Waterproof coating: Apply waterproof coating on LED modules and circuit boards to increase waterproof performance and prevent water vapor from intruding and causing short circuit or damage.
Drainage system: Design a reasonable drainage system to ensure that rainwater can be drained quickly to avoid water accumulation and damage to the lamp.
2. Lightning protection measures
Install lightning rods: Install lightning rods near LED Bollard Light s to guide lightning currents safely into the ground and reduce the direct impact of lightning strikes on lamps.
Improve the grounding system: Ensure that the grounding system of LED Bollard Light s is intact to reduce the risk of damage to equipment caused by current during lightning strikes.
Install lightning protection devices: Install lightning protection devices such as lightning arresters and surge protectors on power and signal lines to prevent lightning currents from entering the lamp through cables.
3. Windproof design
Structural reinforcement: Use a sturdy support structure, such as steel or aluminum alloy structure, to ensure that the LED road column lamp can withstand the impact of strong winds.
Wind load test: Perform a wind load test before installation, and select the appropriate installation method and fixing method according to the local wind level to ensure the stability of the lamp in bad weather.
Regular inspection: Regularly inspect and maintain the fixing bolts and supporting structure of the lamp to ensure that it is stable and reliable.
4. Temperature control
Heat dissipation design: In high temperature environments, adopt efficient heat dissipation design, such as adding heat sinks and fans, to ensure that the internal temperature of the lamp remains within a reasonable range to prevent overheating from reducing the lighting effect or damaging the lamp.
Heating device: In cold environments, install a heating device to prevent low temperature from causing performance degradation or damage to the lamp.
Temperature monitoring: Equipped with a temperature monitoring system to monitor the internal temperature of the lamp in real time, and adjust the working status of the heat dissipation and heating equipment as needed.
5. Optical design
Optimize beam angle: According to the road type and lighting requirements, select a suitable beam angle to ensure that the light can be evenly distributed and illuminate the target area.
Anti-glare design: Anti-glare technology is used to reduce the interference of light to drivers and pedestrians, and improve the safety of night driving.
6. Maintenance and care
Regular cleaning: Regularly clean the LED Bollard Light s to remove dust and corrosion, and maintain the optical performance and appearance of the lamps.
Timely maintenance: When the lamps are found to be damaged or the performance is degraded, they should be repaired or replaced in time to ensure that the lighting effect is not affected.